The return roller for conveyor belt is produced for bulk material conveyors used in mines, sand plants, cement lines, ports and storage yards. The roller shell is normally made from steel pipe, with sealed bearings pressed into both ends and a straight shaft running through the center. We keep the structure simple because maintenance teams usually want parts that can be removed, checked and installed again without special tools.
Product Parameters
|
Roller diameter |
89/108/133/159 mm |
|
Roller length |
200-1600 mm |
|
Shell thickness |
3.0-4.5 mm |
|
Shaft diameter |
20/25/30 mm |
|
Bearing type |
6204/6205/6305 |
|
Surface |
Painted steel or rubber ring |
Product Advantages
Sealed bearings help reduce dust entry during long daily running.
Straight shafts and controlled shell roundness support smoother belt movement.
Return roller for conveyor belt feature painted and galvanized surface finishes to simplify replacement planning.
Standard sizes help buyers match old conveyor frames without large site changes.
Main Applications
1. Quarry and aggregate conveyors where the return belt needs steady support
2. Coal yards, cement plants and loading points with 500 to 1400 mm belt width
3. Replacement work on existing conveyors when the frame position is already fixed
4. Long distance conveyors where low running resistance matters during daily use
FAQ
Q: Can the return roller for conveyor belt be made according to an old sample?
A: Yes. Roller diameter, shaft length, bearing model and end structure can be checked from a sample or drawing.
Q: What information is needed for quotation?
A: Belt width, roller length, diameter, shaft diameter, bearing type and required quantity are enough for a basic quote.
Q: Can rubber ring or galvanized surface be supplied?
A: Yes. These options are usually selected for wet, sticky or outdoor conveying sites.
Hot Tags: return roller for conveyor belt, China return roller for conveyor belt manufacturers, suppliers, factory
